SPT T2-750-3+0-R

Please read the following before installing your SPT T2-750-3+0-R Surge Protective Device:

• Verify the system voltage and configuration on the label if it is appropriate for the application.

• Risk of Electric Shock – Installation and maintenance should be performed by qualified personnel only.

• Disconnect from energized circuits before installing or servicing.

• Safety rules and regulations applicable to all devices connected to power lines should always be followed. National standards and safety regulations must be followed.

• The external mechanical integrity of the device must be checked before installation. Products with visible damage should not be installed.

• Its use is only permitted within the limits shown and stated in these installation instructions. Opening or tampering with the device invalidates the warranty.

• Connecting leads shall be kept as short as possible, without loops and not exceed 0.5m in total length per SPD according to IEC 60364-5-53.

• The minimum distance of the SPD from any earthed conductive surface at which the SPD can be installed is 0mm.