SAN-EARTH M5C

Product information Product name: SanMat

It is an environmentally friendly ground resistance reduction material that uses a by-product of biomass power generation as a conductive material.
It stores CO₂, which causes global warming, in the soil.

・Storing CO₂ in the soil, which causes global warming
・Lightweight compared to conventional products (SanEarth M5C)
・Reducing ground resistance equivalent to conventional products (SanEarth M5C)
・In the case of strip construction, water is not required because it can be installed as a powder.
・The construction length per bag is the same as that of the conventional product (SanEarth M5C)*

* Approximately 3 m (excavation width 0.5 m) for strip construction

Installation Method

Here are the steps for strip construction using sunmats and sunflex wires

1. Dig a trench

Dig a trench with a width of 50 cm and a depth of 75 cm or more (*) at the sunmat construction site. The bottom of the groove should be as flat as possible.

2. Laying of Sunflex Lines

The Sunflex wire is laid in the central part of the buried trench.

3. Laying the sunmat

Roll the rolled sunmat and lay it over the Sunflex wire, and press it so that it wraps around the Sunflex wire.

4. Backfill

After backfilling the soil to a thickness of about 10 cm, taking care not to damage the sunmat, trample it with your foot on top (Part A in the figure below).

After that, the entire trench is backfilled with soil and the ground is leveled (part B in the figure below).